Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

DHCP static IP to Network Printer

Actually my requirement is,i wanted each & every pc & network printers to obtain the IP address from the DHCP server, so when it comes to network printer, the IP address should be static, so i wanted to specify in such a way that one particualr IP should be assigned only for a particular mac-address. so is that possible? also is there any possibility to set a host name also to the pc via dhcp?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: DHCP static IP to Network Printer

Hi

AFAIK u can make use of hardware address option to reserve ip address to the printer based on the mac address of the printer..

hope this link helps u out ..

http://cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a00800ca75c.html#wp1017385

regds

4 REPLIES

Re: DHCP static IP to Network Printer

Hi

AFAIK u can make use of hardware address option to reserve ip address to the printer based on the mac address of the printer..

hope this link helps u out ..

http://cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a00800ca75c.html#wp1017385

regds

Re: DHCP static IP to Network Printer

hi prem,

i tried the configuration, but i didn't work out, i mean it is not taking any IP address on my windows 2000 professional. so how do i proceed now? the client hardware address i specified is the mac-address of the windows 2000 pc.

Re: DHCP static IP to Network Printer

actually when i tried with linux, it really worked, so problem with windows 2000. thankz a lot

VIP Purple

Re: DHCP static IP to Network Printer

Hello,

I think Martin´s original post was right, but you need to add the client-identifier option as well, as described below. Also, I am not sure if the IEEE option is correct, you might want to try the default, which is Ethernet. So, putting this together, try the config below:

ip dhcp pool Mars

host 172.16.2.254 mask 255.255.255.0

hardware-address 02c7.f800.0422

client-name Mars

--> client-identifier 0102.c7f8.0004.22

default-router 172.16.2.100 172.16.2.101

domain-name cisco.com

dns-server 172.16.1.102 172.16.2.102

netbios-name-server 172.16.1.103 172.16.2.103

netbios-node-type h-node

Regards,

GP

143
Views
0
Helpful
4
Replies