I want to have DHCP delivered by the IOS DHCP Service on a C4006 with a SUP III engine. Upon workstation boot and connection to a port on a WS-X4148-RJ45V module, the workstation receives its IP address and is automatically entered into a VLAN based upon that IP address. I want to set 10 VLANS over two VTP-connected C4006-S3 switches ( 8 48-port X4148 modules and 1 48-port X4448). How can I set 10 DHCP pools to be delivered to the workstation based upon membership in a VLAN? Any suggestions would be welcomed.
Yes I saw that but the list price for URT is 39,999 $CAD. A bit steep for my client. I am working on using ip helper-address for each VLAN and using a MS Windows DHCP server to have multiple scopes one for each VLAN. I'll let you know if that works.
Set up a MS Windows DHCP service with multiple scopes. Created Vlans with the same subnets as the DHCP scopes. Put the ports in the VLAN and the workstation successfully get the correct IP address when connected to the port. Can change ports and do an IPCONFIG/release and IPCONFIG/renew and get the correct IP address. Thanks for your suggestions.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...