I have two Cat4006 boxes one with a 4232 router module. I also have about 10 2924 switches all trunked together using dot1q with about 10 vlans set up, basically a router on a stick. What is the easiest way to set up a dhcp server, using the router, on only one or two vlans?
From this URL, i find that the 4232 is not listed in the support list of Cisco IOS DHCP Server. You may have add another router or a PC based DHCP Server in one of the Vlans and extend them to other VLans using ip helper-address.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...