Actually its not so much a matter of client software. when using a cisco as a ras server, you can have it to support callback to any sort of clients wich supports this. I.E ISDN pc clients, modem clients, router and even when using data over GSM.
Its a good idea combining the RAS with a RADIUS for providing authentication and authorization.
At TAC you will find several articals about this.
Here's a link to a dokument that can be a place to start.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...