1)When using dialer profiles, dynamic binding of call to the correct dialer interface is critical or else the call will fail....
2)Within Dialer Profile, there is no method to configure a generic dialer profile (or even a default profile) for a group of users that share the same characteristics. Each user must have its own profile.
Depending on the number of dialin users, we can use combination of virtual profiles (for dialin) & dialer profiles (for dial out).....unless we want to create multiple dialer interfaces for each dialin user.
For you setup to work please refer to (your exact requirement)
NOTE: this holds good if we are going to apply common configs to each dynamically created virtual-access interface, however if we need different values (say like idle timeout for different users) then we need to go with dialer profiles.
We are pleased to announce availability of Beta software for 16.6.3. 16.6.3 will be the second rebuild on the 16.6 release train targeted towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are looking for early feedback from custome...