we want to use a Cisco 801 as access-server to allow one company to dial-in to our network. Because the dial-in should be done from many different locations by PC or Notebook, a mapping can not be done.
The router is configured with dialer-profiles to provide connections to 4 locations.
When a PC dials in, no connection will be established. Debug shows the following output: Incomming call rejected, unbindable.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...