I need to configure a fail over for my WAN link. I have a modem and/or multiple modems hooked up to every router in my network. What I would like to do is to program the serial interfaces and/or the aux port to automatically dial the main frame router should one of the satellite office's frame connection go down, and then hang up once the connection is re-established. I know this is possible, I just don't know where to look to find the configuration examples. Can anyone lead me to this? Thanks in advance.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...