Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Dialer pools and faulty BRI Interface

As a Multilink bundle is being built up it appears physical interfaces

(out of the dialer-pool)are selected sequentially to dial out on based

on the physical port number with the highest used first eg. 1/3 then

1/2 etc.

When I have a faulty ISDN link that prevents the call be placed

multilink can't ramp up any further.

How to I get it to pass-by the faulty channel other than going in and

shutting it down.

2620XM with 12.2(13)T

1 REPLY
New Member

Re: Dialer pools and faulty BRI Interface

try adding this command on your physical interfaces:-

#dialer rotor best

The usage guideline can be found here:-

http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/dial_r/dia_d1g.htm#1019409

hope it helps...

84
Views
0
Helpful
1
Replies
CreatePlease to create content