cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
186
Views
0
Helpful
1
Replies

Dialer pools and faulty BRI Interface

Jed Renton
Level 1
Level 1

As a Multilink bundle is being built up it appears physical interfaces

(out of the dialer-pool)are selected sequentially to dial out on based

on the physical port number with the highest used first eg. 1/3 then

1/2 etc.

When I have a faulty ISDN link that prevents the call be placed

multilink can't ramp up any further.

How to I get it to pass-by the faulty channel other than going in and

shutting it down.

2620XM with 12.2(13)T

1 Reply 1

wfoo
Level 1
Level 1

try adding this command on your physical interfaces:-

#dialer rotor best

The usage guideline can be found here:-

http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/dial_r/dia_d1g.htm#1019409

hope it helps...

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: