If i have several routers (remote offices) configured with dialer profile, dialing in to one central router(headquaters) that has a PRI. Do i need to configure a dialer profile for each remote location on the central (headquater) router? or just one dialer profile will work? Thanks
You have a choice here, and what you choose depends upon scalability and the pain in the backside factor!!
Either configure a dialer interface on the HQ router for each, as you suggested, which can be a pain when the amount of remote routers expands as you have to manually create a dilaer for each...
On the HQ router configure a Virtual-Template. This will, as the remote routers dial in, recognise that there is no dialer profile to be assigned and create a Virtual-Access interface for the duration of the call. You can use MLP if required i.e.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...