Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Dialing to a Win2K

I am configuring a Cisco to dial to a Win2K server, but the authentication does not seems to go over. I've tried using chap and pap. Both are unsuccessful. Is there any additional configuration needed ?

1 REPLY
Anonymous
N/A

Re: Dialing to a Win2K

I think that the Win server may only

support MSCHAP, which we don't

support in client/challenged mode. If

possible, you should see if the WIN

server supports PAP; then configure the

cisco with a pap username and password.

"debug ppp authen" on the cisco will

show you what is going on, too.

84
Views
0
Helpful
1
Replies