I use cisco's DialOut utility using 2 AS5300's. I'm trying to figure out a way to set up failover redundancy. Since the DialOUT client only allows you to specify one IP address of hostname of the As5300, I do not know how to set up failover to point to my other 5300 if that the current one goes down. Is there a way to set up a DNS alias or something that can include all the possible AS5300's that the client can point to? This way if one IP address does not respond, the client will use the next ip address associated with this alias?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...