Re: Dialup connection and authentication takes long time.
Is it possible that the first one configured is unreachable (for whatever reason)? In that case the AS will timeout after waiting for a response from the first server, then contact the second one and succeed in authenticating the user?
In other words, check if the AS can reach the first defined radius server?
As I said before, "debug aaa authentication" may help with this.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...