Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Difference Between Syslog Message and SNMP Trap Syslog

Hi,

Anybody know the difference between Syslog messages and SNMP Trap Syslog?

Thanks.

3 REPLIES

Re: Difference Between Syslog Message and SNMP Trap Syslog

If you enable SNMP Trap Syslog the device sends a SNMP trap to your management station every time it's writing a syslog message.

I recommend disabling SNMP Trap Syslog if your Syslog is working OK.

Regards,

Milan

Community Member

Re: Difference Between Syslog Message and SNMP Trap Syslog

Thanks.

Community Member

Re: Difference Between Syslog Message and SNMP Trap Syslog

btw with these syslog config on my catos, will i be able to receive all syslog messages including all severity level of specified facility? thanks.

#syslog

set logging console enable

set logging server enable

set logging server x.x.x.x

set logging server x.x.x.y

set logging level cdp 7 default

set logging level mcast 7 default

set logging level dtp 7 default

set logging level dvlan 7 default

set logging level earl 7 default

set logging level ip 7 default

set logging level pruning 7 default

set logging level snmp 7 default

set logging level spantree 7 default

set logging level sys 7 default

set logging level tac 7 default

set logging level tcp 7 default

set logging level telnet 7 default

set logging level tftp 7 default

set logging level vtp 7 default

set logging level kernel 7 default

set logging level filesys 7 default

set logging level pagp 7 default

set logging level mgmt 7 default

set logging level mls 7 default

set logging level protfilt 7 default

set logging level security 7 default

set logging level radius 7 default

set logging level udld 7 default

set logging level gvrp 7 default

set logging level cops 7 default

set logging level qos 7 default

set logging level acl 7 default

set logging level rsvp 7 default

set logging server facility LOCAL7

set logging server severity 4

set logging buffer 500

set logging timestamp enable

301
Views
0
Helpful
3
Replies
CreatePlease to create content