Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Difference between these two configurations

Hi All,

The interface configuration for B port at Switch Z seem to have some error when connect to the PC.

1) I would like to know what is the major faults in "B" for the configration compare to "A"

2) With "B" configuration, the PC doesn't grab an valid IP and cannot surf the internet. The problem only resolved when a re-boot is done to the switch. Does it related to "B" configuration?

(A)

switchport access vlan x

switchport mode access

switchport voice vlan y

mls qos trust device cisco-phone

mls qos trust cos

storm-control broadcast level 20.00

storm-control multicast level 20.00

wrr-queue bandwidth 10 20 70 1

wrr-queue min-reserve 1 5

wrr-queue min-reserve 2 6

wrr-queue min-reserve 3 7

wrr-queue min-reserve 4 8

wrr-queue cos-map 1 0 1

wrr-queue cos-map 2 2 4

wrr-queue cos-map 3 3 6 7

wrr-queue cos-map 4 5

priority-queue out

switchport priority extend cos 0

spanning-tree portfast

spanning-tree guard root

cdp enable

(B)

switchport access vlan x

switchport voice vlan y

switchport priority extend cos 0

no ip address

mls qos trust device cisco-phone

mls qos trust cos

storm-control broadcast level 20.00

storm-control multicast level 20.00

wrr-queue bandwidth 20 1 80 1

wrr-queue min-reserve 1 5

wrr-queue min-reserve 2 6

wrr-queue min-reserve 3 7

wrr-queue min-reserve 4 8

priority-queue out

spanning-tree portfast

spanning-tree guard root

1 REPLY

Re: Difference between these two configurations

"Switchport mode access" configuration missing on interface.

193
Views
0
Helpful
1
Replies