Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Disable DFM Polling Voice MGCP Serial Interfaces!

Is there a way to torn off DFM from polling the Serial Interfaces in a MGCP voice gateway? Otherwise it reports a fault every time a call is made and torn down. I would still want DFM to poll the T1 interface and the other interfaces... Just not the serial interfaces. It also appears that every time a call is made, thus a new serial interface is created, DFM sees this as a NEW interface!!! So I can un-manage them, but new ones keep appearing!!!


New Member

Re: Disable DFM Polling Voice MGCP Serial Interfaces!

First under the serial interface configure: no logging event link-status

Under the DFM Administration console create your own customized interface threshold group. Go to Threshold tab -> Select Interface Group -> Group (New Group). Setup the matching criteria (name e.g) and set it to a higher priority than the default serial group. Do a reconfigure and the serial interfaces should appear under the newly created group.

CreatePlease to create content