Disabled port on the POE module

[pmpesha]

Greetings,

I do have two Access Points installed on a powered module on my 6500 switch. The AP's are installed on port 7/27 and 7/34. When I do disable port 7/34, port 7/27 get shut down. I can disable port 7/27 fine without causing a problem on 7/34. Does any one ever seen this behavior? By the way I had my cabling tech test the cabling on the punch pannel, and did not find anything unusual. Thank you for your help.

[ssoberlik]

not sure of the issue, check out if the following links help :

http://www.cisco.com/en/US/products/hw/wireless/ps430/prod_technical_reference09186a008039e541.html#wp35557

http://www.cisco.com/en/US/products/hw/switches/ps708/products_white_paper0900aecd80233a77.shtml