09-11-2002 09:09 AM - last edited on 03-25-2019 02:41 PM by ciscomoderator
This question was submitted yesterday on how to disable MLS IPX on a 6500 with an MSFC. There is a line on the switch that reads:
#mls
set mls enable ipx
I was told to disable IPX MLS on the msfc but when doing so it said that it was already disabled. How do I remove this line? "set mls enable ipx"
09-11-2002 10:46 AM
On the catalyst switch, did you enter "set mls disable ipx"
eg.
Console> (enable) set mls disable ipx
IPX Multilayer switching is disabled
Console> (enable)
Steve
09-11-2002 10:50 AM
I will give that a shot. Thanks Steve.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: