I have 2 3640 with PRI for dial in access both set up to disconnect users after 10 min of inactivity. but only one of the routers disconnects I have included the setup for the PRI can anyone give me any pointers as to what is wrong. I know that the routers are not running the latest IOS but something works on one router and not the other.
This router disconnects the users after 10 min, but there is no interface Loopback0 defined.
Version 11.2
controller E1 1/0
pri-group timeslots 1-8,16
interface Serial1/0:15
ip unnumbered Loopback0
encapsulation ppp
dialer idle-timeout 600
no ip mroute-cache
autodetect encapsulation ppp v120
isdn incoming-voice modem
peer default ip address pool remote
dialer-group 1
no cdp enable
ppp authentication chap
hold-queue 75 in
This router dose not disconnect
Version 12.0
controller E1 1/0
pri-group timeslots 1-12,16
interface Loopback0
no ip address
no ip directed-broadcast
interface Serial1/0:15
ip unnumbered Loopback0
no ip directed-broadcast
encapsulation ppp
dialer idle-timeout 600
dialer-group 1
autodetect encapsulation ppp v120
isdn switch-type primary-net5
isdn incoming-voice modem
isdn sending-complete
peer default ip address pool Modem_Pool
fair-queue 64 256 0
no cdp enable
ppp authentication chap
