Discovering and managing with SNMP RW, and SNMP RO access
Hello. I have a network that is split into 2 parts, and have latest CW LMS and RWAN. The first part of the network is all mine, and I have RW access to it all. This means I can discover and manage to my hearts content. However I also have the WAN side of the network where I can only RO SNMP (and cannot have RW). I have multiple different IP ranges to manage, so how do I easily add them to the ANI? Without entering them as seeds one by one. Also a lot of networks are split like this. Any best practices on managing it through CW? Many thanks in advance.
Re: Discovering and managing with SNMP RW, and SNMP RO access
Hello. As a general rule, consider Campus Manager as a LAN application ('LAN' Management Solution) - it is not really designed for use with WANs. Normally, if I were to connected to a device over a WAN link then I would configure the device as a seed
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...