not sure about your question. Heres the answer on the disk vs slot issue
Flash memory cards use similar commands. The primary syntax change is that disk0: or disk1: refers to Flash memory ATA disks, while slot0: or slot1: refers to Flash memory cards. Generally, use the syntax slot0: for Flash memory cards less than 20 MB, and use disk0: for Flash disk greater than 20 MB. Keep in mind that there are 32 MB linear PCMCIA Flash cards where you use slot0.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...