Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Display default settings

Is there a way to display the default settings using "sh start" command? For example. "ip load-sharing per-destination" does not show in "sh start". How can I get all the information to display?

1 REPLY
New Member

Re: Display default settings

So far there is no way to do that on the router. On the switches you can do a "show config all".

This feature (to show the full config) was requested couple years ago even by Cisco's internal tech support department (as they have to deal with different IOSes that have different defaults) but Cisco has not done it yet.

Regards,

Pritish

75
Views
0
Helpful
1
Replies
CreatePlease to create content