Can someone please tell me how to show the clock source for the ATM interfaces on an IMA card in a 7200? 'show controller ATMx/y' does the job on a 3600, but that command gives very different output on a 7200.
I had done that, but the clock source was not apparent. I've done some more digging and found that the value of "txtiming" tells you the clock source. A value of 0xA means Line and a value of 0xE means Internal.
Thanks for helping me find the answer to my question.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...