I'm running into TCAM table problems on our Hybrid 6509 [6.4(3)/12.1(19)E1]. The error message is "%ACL-3-TCAMFULL:Acl engine TCAM table is full". I have researched it some, and I know what the problem is (we need to trim our ACLs), but I've seen multiple references to using "show tcam count" to check on used/available TCAM resources, and this command doesn't work on our box. I can't "sh tcam" anything, in the MSFC2 or the Sup2.
I'd like to know the command to do this, so we can forecast events like this instead of blindly running into them.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...