Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Distribute Image Job Successful but...

We recently distributed a new image 12.0 (25) for a Cisco 2524 router with 11.3 (6) code. The job completed successfully but when the router reloaded it came with serial interfaces 'shutdown'. Can someone please highlight if there are any known issues with these routers or is it a normal behaviour? Thanks.

regards,

Murali

1 REPLY
Silver

Re: Distribute Image Job Successful but...

Not sure why that happens, but you can give a 'no shutdown' command on that interface to bring it up immedietly.

I have seen this happen too. Just curious on why is this happening? Any clues?

76
Views
0
Helpful
1
Replies
CreatePlease to create content