We are a big BICSI corporate member, and do a lot of Structured Cabling System (SCS) design. Under BICSI, the new standard for design specifications will be under Division 25000. (following the CSI model) The LAN section is 252xx, the WAN is 255xx, and Voice is 253xx. Are there any other consultants and designers utilizing the new Division 25 format yet?
No, I am referring to design standards. In order to write up a network specification, it should be formatted correctly. The accepted standard in all of construction, to include plumbing, electrical, masonary, etc. are the division standards. Telecommunications is the proposed Division 25 format. Most integrators don't write up full designs, just do them. Division 25 covers all configurations, and installation procedures. Please feel free to contact me at firstname.lastname@example.org if you have any further questions.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...