Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

DLSW and QoS

Hello community,

my company is running DLSW+ and we want to mark this traffic to precedence 3. I read in the following link http://www.ciscopress.com/articles/article.asp?p=357102&seqNum=3 that by default DLSW traffic is marked with precedence 5 and in order to change the marking you should disable dlsw tos.

I marked it on 2 different routers once disabling dlsw tos and once leaving it as it was. I was able to mark it to precedence 3 in both situations.

Is there another reason I should disable dlsw tos or since it works fine with default configuration, just leave it at that?

Thank you in advance,

Katerina

2 REPLIES
Bronze

Re: DLSW and QoS

No reason from a dlsw point of view to disable or change the TOS settings. The only issues we have seen have a been a couple oif migrations to mpls networks where the default tos markings were causing the packets to be dropped and we had to set to 0.

Matthew

New Member

Re: DLSW and QoS

Hello Matt,

thank you for your answer. Since we are migrating from Frame-relay to MPLS I am going to leave the TOS value as it is, change the precedence and if the marking fails, then disable dlsw TOS.

Katerina

413
Views
0
Helpful
2
Replies