Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

DLSw / AS400 and Printer Pausing

We currently have three seperate Frame Relay WAN's. Most traffic is DLSw from IBM Controllers to AS/400 via TCP/IP.

Problem: Recently, the print jobs sent from the AS400 pause until a key is pressed on a terminal.

This problem only happens on ONE of our Frame Carriers, not the other two AND this problem just now started (the WAN has been in place for three years). No IOS or Hardware changes.

In debugging I noticed that this line is missing (and DLSw Traffic stops) during a pause:

%DLSWC-3-RECVSSP: SSP OP = 10( INFO) from peer x.x.x.x(xxxx)

It normally appears after this line (which was there)

%DLSWC-3-SENDSSP: SSP OP = 10( INFO ) to peer 10.254.100.1(2065) success

P L E A S E H E L P

What could the telco be doing that would hinder DLSw traffic

1 REPLY

Re: DLSw / AS400 and Printer Pausing

Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

104
Views
0
Helpful
1
Replies