Have you considered "statically" configuring your reachability cache on the PROD 7513/backup 7513 with a "dlsw icanreach mac" command ? Also, you can use costing as opposed to the "backup peer" configuration for quicker failover/recovery. Basically, if you make the cost of the backup 7513 greater than the PROD 7513, the 3640 will always have 2 connected peers but will prefer the PROD 7513 until it fails. If there is a failure on the PROD 7513, your peer will already be connected and ready to use for the backup 7513 . Good luck !
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...