We have DLSW using Border peers. What I need to know is - if I was to add another router (external router) to peer with our DLSW network does this router need to be part of a peer group or can I configure a local peer statement and a remote peer statement pointing to our Border peer:
dlsw local-peer peer-id 22.214.171.124 prom
dlsw remote-peer 0 tcp 126.96.36.199 (our border peer)
dlsw local-peer peer-id 188.8.131.52 group 1 border prom
dlsw remote-peer 0 tcp 184.108.40.206
so, do I need to create a group just for this one router?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...