You can't define a secondary DLSw local peer, but you can assign the local peer to be a loopback address. That way, as long as your routing protocol can find a path to any interface on the router, the local peer will be reachable from remote peers.
There are also several other "DLSw redundancy" issues you should consider, particularly if using DLSw on Ethernet interfaces. These are discussed on www.cisco.com and in Chapter 10 of my book "High Availability Networking with Cisco." You might also find the white paper on my web site " Cisco 11.2 IOS Configuration for Redundant DLSw Connecting Ethernet Attached Devices" of interest.
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...