Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Do not work Network Show Command in Ciscoworks2000

When I do Resource Manager Essential>Configuration Management> Network Show Command> and try to submit a show command (i.e. show cdp...)on any device the application shows this message:

Report for 10.1.1.1

Error: PGM_NM=Configuration Archive:6787:TYPE=unassigned message file:Failed to execute commands for device:10.1.1.1

Probable cause:PGM_NM=Configuration Archive:6787:TYPE=unassigned message file:Failed to send command to remote host:Did not get device prompt

Recommended action:check connection to remote host

And all device are working fine and snmp community is fine too and I cand see device in others CiscoWorks options (i.e. syslogs, campus)

Cisco Works2000, RME3.3,on a Windows2000 server

Thanks

Windston

1 ACCEPTED SOLUTION

Accepted Solutions
Purple

Re: Do not work Network Show Command in Ciscoworks2000

Almost sounds like you have incorrect telnet passwords configured in your archive , I would check those as it uses a telnet session to do these commands .

2 REPLIES
Purple

Re: Do not work Network Show Command in Ciscoworks2000

Almost sounds like you have incorrect telnet passwords configured in your archive , I would check those as it uses a telnet session to do these commands .

Community Member

Re: Do not work Network Show Command in Ciscoworks2000

Thats rigth

Thanks

88
Views
0
Helpful
2
Replies
CreatePlease to create content