cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
258
Views
0
Helpful
1
Replies

Does 2611(Not XM) support Full Duplex

sdrennan
Level 1
Level 1

This is a simple question that I cannot find documented on CCO. My tests are also inconclusive.

Configuring the Ethernet port it will take the command " full-duplex" however it does not show status in the show interface command, there is no FDX LED at port.

Can anybody confirm if they are 100% sure of answer

1 Reply 1

loub
Level 1
Level 1

I have a 2611 in my lab so I conducted a test. You are correct. There is no way to verify that the interface is either half or full duplex. I set e0/0 to full duplex and the switch port to half duplex. I did get an error CDP-4-DUPLEX_MISMATCH right away. Once I adjusted int e0/0 back to half duplex the error did not return. I repeated the test with a show controllers ethernet 0/0 and the output will tell you if the interface is in half-duplex or full-duplex.

Hope this helps.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco