Does Cat65009 running Sup IOS 12.1(8a)E support WS-X6381-IDS module ?
I'm planning to deploy a module IDS (WS-X6381-IDS) using with Catalyst 6509 running Native IOS ( 12.1(8)E ) but I wonder if this IOS level has supported such IDS module ? Please send me some information ?
Re: Does Cat65009 running Sup IOS 12.1(8a)E support WS-X6381-IDS
Please help me solve this case ?
Imagine that I will dedicate the IOS 12.1(11b)E to the platform for my Cat6509 and assign some subnets on my network to some VLAN configured on some respective Fast Ethernet ports on a module WS-X6348-RJ-45. I want to limit the Internet access rates of those VLANs like the such way of CAR on the Cisco 7600 series router. Because Cisco 7600 router may run on the above IOS,so may I obtain exactly the same results on Cat6509 ? Please show me some restrictions and recommendations ?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...