Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
298
Views
0
Helpful
1
Replies

Does IP address secondary and HSRP work on VLAN interfaces

admin_2
Level 3
Level 3

‎06-24-2002 02:38 PM - edited ‎03-01-2019 10:32 PM

A Cat 5509 has two supervisor modules with RFSC running HSRP. One of the VLAN's is connected to a TELCO LAN extension service (XYlan switch). The TELCO will soon be adding more remote sites to their LAN Extension service. The requirement is to support several IP subnets on the same VLAN interface. The TELCO does not support any kind of trunking or VLAN encapsulation. Because of this, it seems to be necessary to configure secondary addresses on the VLAN interface. Will this cause any problems with HSRP. Can we configure multiple 'standby IP' statements?

Labels:
0 Helpful
1 Reply 1

Not applicable

‎06-24-2002 02:38 PM

You can configure different stanby groups for different network

between 1 -to- 254. It should work just fine but remember it has

to be a different standby group per subnet (i.e. seconday network configured).

0 Helpful
Customers Also Viewed These Support Documents