Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Does the NM-16AM support V.90 at 56kbps?

I want to choose a network Module which can support 56kbps for users Remote access.Does the NM-16AM support V.90 at 56kbps? Is there any other NM can support it?

1 REPLY
Anonymous
N/A

Re: Does the NM-16AM support V.90 at 56kbps?

The NM-16AM only supports speeds up to 33.6 kbps (V.34bis). If you want to support V.90 speeds then you will have to move over into a Digital Modem solution. The hardware you would use in the 36xx would be the NM-xCT1-CSU and NM-24DM. You would also have to install either a PRI or CAS T1 circuit and have it terminate into a NM-xCT1-CSU. This will allow your dial-in users to terminate incoming data calls on the NM-24DM and ISDN users (if using a PRI circuit) can terminate on the PRI B channels (NM-xCT1-CSU).

407
Views
0
Helpful
1
Replies
CreatePlease to create content