You use this command to tell the router to regard looped interface as down. In this case router choose another path to route packets via dynamic routing or via another static route. Route, which points to interface which is down is automatically removed from routing table.
I search a command to desactivate the router interfec to become looped when there is many interrupts in modem. This command (ignore-hw local-loopback ) resolve my problem, but i dont understand how i uses it .
You use this command when modem experiences short outages and a result of it interface can come into loopback state. The signal to enter the loopback state comes into interface through pin #18 of RS-232. The command you specified makes interface ignore any signal on pin #18, so interface will not go into loopbacked state.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.