Just wondering if anyone else out there has tried to do equal cost multipath with multiple DSL connections using NAT. I am in a situation whereby no matter what I try, I get per-packet load sharing instead of per-destination. Enabling CEF / Dialer CEF does nothing too and it is getting very frustrating.
Sorry - also running 12.3.2T (tired 12.3.1 and 12.3.1a to no avail.). Incidentally, tested Dialer CEF on ISDN and that works fine, so I think it has to do with the fact that Dialer CEF on ATM actually goes through another virtual layer (virtual-access) and does not see the underlying physical ATM interface...as opposed to ISDN where CEF sees Dialer->BRI.
A 2611 should be able to run per destination load sharing.... What's in the config? Is show cef or show ip cef showing per packet load sharing? Or what other indicator are you using to determine the router is running per packet load sharing?
Never mind Russ, been confirmed as IOS bug. There is an issue where CEF doesn't see the ATM interface as the underlying physical hardware. Something to do with aal5 encapsulation...! Cisco working on it. Thanks for the help. Probably should have explained that I already have CEF working on Serials, ISDN diallers and Fast Ethernet interfaces.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.