Static IPs are provided by the ISP. One Static IP would be used for the 678 DSL interface. The 1720 would be the DHCP server. Question (a) Can NAT be configured on the 1720? Question (b) Can the VPN/IPsec be configured on the 1720? Question (c) What else should I be aware of with this design? Thank You
I would install (1) a static route on the 1720 wic0 interface pointing to the ISP's network address of the static IP of the 678 WALL interface and (2) a default route installed on the 1720 wic0 interface:
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...