YOu can either use a DSL modem which will have a wan IP, and a lan ip to talk to computers on the inside. Most new modems are built in routers with DHCP and firewalling, so has a lan as well as wan ip. There is another mode of configuration for most DSL routers, where the DSL Modem acts as a bridge and you can still use another router or firewall (like pix) on the inside (lan side) and run PPPOE on the router or firewall to authenticate with the service provider and acquire an ip address (public). In this case the DSL modem usually dont carry an ip address (bridged mode).
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...