Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

dte to dce

I have 2 AGS+ routers with a dce cable on one and a dte cable on the other to connect serially back to back. The interfaces do not stay up for more than about a minute. Can't figure out why not.

4 REPLIES
New Member

Re: dte to dce

Hi,

be sure that you have defined the clock rate on the device where your dce cable is connected to.

New Member

Re: dte to dce

If i remember in the right where, there are some jumpers on the blades to config the interface from dte to dce. Of cource, you have to configure also the clockrate.

New Member

Re: dte to dce

Clocking has been configured. I do remember seeing some documentation on jumpers though. I will check that again. Thanks.

New Member

Re: dte to dce

Make your Serial 0 the DCE side of the cable,

The clock rate will be 64000.

Just had the same issue, when setting up the home lab!

131
Views
0
Helpful
4
Replies