Dynamic Trunking Protocol (DTP), as the name implies is the protocol used to automatically negotiate a trunk link.
For example, SwitchA and SwitchB are connected on their FastEthernet 0/1 interfaces. If both switches are set to access mode, then the link is a non-trunking link. Both interfaces must be on the same VLAN and only that single VLAN is transmitted across the link.
Since the command switch mode access Set trunking off.
Does a port which is in switch access mode generate DTP frames ?
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...