Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
295
Views
0
Helpful
2
Replies

Dumb vlan bridging question

kaumell
Level 1
Level 1

‎04-14-2006 07:34 AM - edited ‎03-03-2019 02:49 AM

I have a Cat6509, I have a small vlan (vlan4) that needs access to vlan1. We currently have a valn2 that is mapped to vlan1 as well, if that matters.

How can I make this link between vlan4 and vlan1 happen?.

Thanks in advance for any help

Labels:
0 Helpful
2 Replies 2

Bobby Thekkekandam
Cisco Employee
Cisco Employee

‎04-14-2006 08:44 AM

Do you have VLAN interfaces for vlan 1 and vlan 4 with IP addresses for these two VLANs? If so, and you have IP routing enabled globally, that should be all you need.

If not, I'd suggest configuring the aforementioned VLAN interfaces for the two VLANs and enabling IP routing globally.

HTH,

Bobby

0 Helpful

kaumell
Level 1
Level 1
In response to Bobby Thekkekandam

‎04-14-2006 08:48 AM

I do have the interfaces set up, but do not have ip routing enabled globally. I"ll give that a shot. Thanks for the advice

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents