Is it possible to configre Neighbor x.x.x.x under router rip convert RIP broadcast to point-to-point unicast. and Then configure acces-list to allow UDP 520 (RIP) to pass through PIX ( like BGP TCP 179 pass through PIX) . so that dynamic routing update will pass througout PIX ??
Using the neighbor command will indeed convert it into a unicast packet. Combine this with the passive interface command to save bandwidth and prevent others from receiving the packets.
However, the issue will be the TTL of the packets. It is set to 1, so it won't get through the PIX. The only way I can see around this is alter the TTL or create a tunnel through the PIX (GRE or ipsec).
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.