Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Bronze

E1 IMA and STM-4

Hi,

I must to terminate 60 8E1 IMA (60x8E1) to a datacenter.

if all of lines are multiplexed to two STM-4 , how can demultiplex them into one switch/router? by which modules?

I would be appreciate if you advice me.

Regards,

M.A.Rad

1 REPLY
New Member

Re: E1 IMA and STM-4

Sounds like whoever is your carrier will need to support the IMA first and having the IMA module in their switch.

Remote end doesn't have to be IMA, but the ATM switch needs to be IMA.

86
Views
0
Helpful
1
Replies
CreatePlease to create content