Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

E1 Remote Loopback

How do I configure remote loopback for a E1 link on a cisco Router. I could do it for T1 using the FDL. But for E1 I can't find any commands for remote loopback configuration.

Any help related to this is appreciated.

Thanks

2 REPLIES
Bronze

Re: E1 Remote Loopback

Seeing the following document i am forced to beleive that you cannot configure the remote loopback for an E1 link.

It is possible with the DS3 link or channelized T1.

http://www.cisco.com/en/US/products/sw/iosswrel/ps1831/products_command_summary_chapter09186a0080087bf3.html

New Member

Re: E1 Remote Loopback

Hi,

Yes you definitely cannot go for remote loopback in case of E1 as per the IOS commands,But definitely if anybody could tell us if some alternative is there.

I am lso in doubt what loopback commands are there on D channel

Can U explain me if u know

Example int serial 1/0:0 , loopback remote/local

what these commands are used for

Regards,

Munit

178
Views
0
Helpful
2
Replies