If the PTT drops off a full E1 Structured/G.704 circuit with either a X.21 or V.35 interface for me to use---can I plug that directly into a CSU/DSU or Channelized E1 card. Will either of those or both of them take either of those serial interface handoffs?
The reason I ask is because I will only need to utilize time slots 1-8, not the full E1, even though the PTT is giving me the whole E1--so I need to be able to take the X.21 at one site and V.35 at another site and plug that into something to break it down to the appropriate port size.
Basically you need the fractional convertor. On fractional convertor you can terminate your mail link i.e. Full structered E1 can be terminated and afterwards you can configure the data port ( v.35 or x.21) for your desired speed.
The example for this kind of device is RAD make FCD.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...