Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

eigrp and stub networks

I have two spoke networks connected to a larger mesh network via one router. I would like to implement stub routing on these two spoke routers. I understand how to enable eigrp stub routing, but I am unclear on how to summarize these two spoke networks at the dist router. I don't want to use auto summary on the dist router because of the many different networks it routes for. I was thinking about manually summarizing at the spoke router Ser 0/0 interface.

Will this manual summary address get propagated into the dist router and hence all the other routers? Would I have to allow the summary option in the eigrp stub function?

2 REPLIES
Gold

Re: eigrp and stub networks

you ar eessentially correct. feed the summarized routes upstream on the link to

the upstream router. the receiving router should install a sunnary route in its table for the aggregated addresses.

Silver

Re: eigrp and stub networks

Yes, go ahead and manually summarize the networks at the spoke router interafces, and that would be perfect. Also, eigrp stub command by default sends connected and summary routes as updates, so adding only "eigrp stub" is fine.

238
Views
0
Helpful
2
Replies
CreatePlease to create content