09-02-2003 12:57 AM - edited 03-02-2019 10:01 AM
I find the error message : "%DUAL-3-INTERNAL: IP-EIGRP 1: Internal Error
-Traceback= 60AA6ADC 60AA6C64 60AA76D8 60AA777C 60A9CB78 60A9CBE8 60A9CDF4 60A9CEFC 60A9EEC0 60A9EF68 60A9FE5C 609E4698" in the log of a Cisco7200 router. The Error Interpreter says this is a generic software or hardware error. I would like to know that could be the cause of this error message and that actions should I take in order to stop it.
09-02-2003 03:03 AM
This is a software error, most likely a defect. If you can open a tac case, they can decode the error message for you, and track down the defect for it. If not, post a show version here, and I can do it.
Russ.W
09-02-2003 04:47 AM
Thank you for your reply.
The router is working, but a new Dual-Eigrp Internal Error message is generated each minute. Do you think a relaod is enough in order to stop this error notification?
The sh version:
Cisco Internetwork Operating System Software
IOS (tm) 7200 Software (C7200-IS-M), Version 12.2(10b), RELEASE SOFTWARE (fc1)
Copyright (c) 1986-2002 by cisco Systems, Inc.
Compiled Fri 12-Jul-02 06:50 by pwade
Image text-base: 0x60008940, data-base: 0x612B2000
ROM: System Bootstrap, Version 12.2(1r) [dchih 1r], RELEASE SOFTWARE (fc1)
BOOTLDR: 7200 Software (C7200-BOOT-M), Version 12.0(13)S, EARLY DEPLOYMENT RELEA
SE SOFTWARE (fc1)
ulisse uptime is 7 weeks, 5 days, 23 hours, 42 minutes
System returned to ROM by power-on
System restarted at 14:53:54 MEST Wed Jul 9 2003
System image file is "sup-slot0:/c7200-is-mz.122-10b.bin"
cisco 7204VXR (NPE225) processor (revision A) with 114688K/16384K bytes of memor
y.
Processor board ID 26800588
R527x CPU at 262Mhz, Implementation 40, Rev 10.0, 2048KB L2 Cache
4 slot VXR midplane, Version 2.6
Last reset from power-on
Channelized E1, Version 1.0.
Bridging software.
X.25 software, Version 3.0.0.
Primary Rate ISDN software, Version 1.1.
2 FastEthernet/IEEE 802.3 interface(s)
124 Serial network interface(s)
8 Channelized E1/PRI port(s)
125K bytes of non-volatile configuration memory.
46976K bytes of ATA PCMCIA card at slot 0 (Sector size 512 bytes).
4096K bytes of Flash internal SIMM (Sector size 256K).
Configuration register is 0x2102
09-02-2003 05:27 AM
It looks like it could be CSCdy74505 or CSCdw40036, but I'm not certain about it at the moment. I'm checking with a coder at the moment.
Russ.W
09-04-2003 09:35 AM
CSCdv89555 is where this fix was committed. If you have problems finding out where this is committed, etc., let me know.
Russ.W
09-04-2003 11:43 PM
I can not find bug ID CSCdv89555 in Cisco Bug Toolkit. Could you please let me know which IOS rel. fix it.
Thanks.
09-05-2003 08:25 AM
It should be in 12.2(15T).
Russ.W
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: