I have 2 wan routers A and B sitting on the same lan running EIGRP to multiple spoke sites. The network is a fully-meshed frame relay network. From Router A I can see all remote sites lans in the routing table and can see alternate routes in the eigrp topology table. I have a problem with remote Site Y though. This site terminates on WAN router A. However from Router B, I cannot see the route for this site Y over the shared ethernet lan from Router A in the topology table. I can see other alternate routes for this site from other remote sites terminated on Router B even though the FD advertised is greater than the FD for site Y.
This site Y is the only site affected, all other sites are okay. CDP works across the lan etc.,
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...